Fns Adjusting The Three-Holding Positions (Fn-6 Only) - Minolta Di551 Service Manual

[24] FNS Adjusting the three-holding
positions (FN-6 only)
1. Tool
• Screwdriver (Phillips)
2. Adjustment method
a. Preparation
Step
Make sure that the "Adjusting the angle of
1
the folding stopper" is finished.
Execute three-holding and check whether
the three-holding positions are within spec-
ification.
a
2
b
Reference value Specifi-
Folding
positions
A4R
a 93
b 102
c 102
Unit:mm
If the three-holding positions are out of
3
spec, perform the following adjustment:
Operation
c
cation
8.5x11
±2
86.4
±2
97
±2
97
2-131
b. Adjustment
Step Operation
Power on the main body. Use "7: Three-
hold positions adjustment" from "6: Fin-
isher adjustment" on the 36 Mode, adjust
1
the first folded line (reference value a), and
perform three-holding.
When the first folded line becomes within
the spec value, open the front door and pull
2
out the stacker unit.
Open the three-holding guide plate, loosen
the two screws securing the three-holding
stoppers, and adjust the stopper positions
using the mark as a guide.
3
4
3
1. Marks
2. Three-folding guide plate
3. Three-folding stopper
4. Screw
After the adjustment, retighten the two
screws and execute three-holding to check
4
that the three-holding positions are within
the specification.
ADJUSTMENT
1
4 2