Setting The Pm Cycle; Collecting Data - Minolta Di551 Service Manual

[6] Setting the PM Cycle

This function allows you to change the PM cycle.
Caution: The PM cycle is factory-set. Use this
function to change the factory-set PM
cycle.
Step
1 Enter the 25 mode.
2 [Memory setting mode menu Screen]
Select " PM count".
3
3 [PM count/cycle Screen]
Press the
PM Cycle Setting
4 After making sure that three digits of the
cycle value are displayed in reverse video,
enter a desired cycle value using numeric
keys.
Only the three digits of the cycle value can
be entered. The entered digits will be
shifted to the left one after another.
5 Press the
OK
To cancel the new setting, press the
key.
CANCEL
Pressing either key will display the Memory
setting mode menu Screen again.
Operation
key.
key to finish setting.

[7] Collecting Data

This function allows you to view various data retained
by the machine.
1. Data that can be Viewed
No. Data Type
Total count of
1
each paper size
Copy count of
2
each paper size
Print count of
3
each paper size
RADF count
4
Pixel ratio of each sec-
5
tion
Pixel ratio ranking list
6
JAM occurrence count
7
Count of each copy
8
mode
SC occurrence count
9
Paper conveyance time
10
data
JAM count of each sec-
11
tion
SC count of each sec-
12
tion
Note: When bit 1 of DIP switch 30 is set to 0,
only collected data 1 to collected data 6
can be viewed.
2-25
ADJUSTMENT
Pre-operation
Enter the 25
mode, select "
1
Software DIP SW
Setting", and set
bit 1 of address
30-1 to 1. (Note)