Minolta Di551 Service Manual page 264

<Installing the Up/Down Wires>
Wire B
Wire A
7.Insert wire A in the
pulleys, then attach a
metal ball.
15.Insert wire C in the
pulleys, then attach a
metal ball.
12.Insert wire D in the
pulleys, then attach a
metal ball.
10.Insert wire B in the
pulleys, then attach a
metal ball.
Wire C
Wire D
13.Insert wire C in the up/
down shaft, attach a pul-
ley, and secure the pulley
with an E-ring.
14.Wind wire C around the
pulley by 6 turns in such a
manner that the wire can
be pulled from over the
pulley.
6 turns
11.Insert wire D in the up/
down shaft, attach a pul-
ley, and wind wire D
around the pulley by six
turns in such a manner
that the wire can be pulled
from over the pulley.
6 turns
Up/down plate
Wire B
Wire A
FRONT
Insert wire A in
1.
6.
the up/down
shaft, attach pul-
leys, then pull the
wire A from under
the pulleys.
Insert wire B in the up/down
3.
shaft, attach a pulley, and
8.
secure the pulley with E-
rings.
4.
9.
1-Q-9
C-403 / C-404
20.Insert wire B in the pulleys,
then attach a metal ball.
2.Insert wire A in the pulleys,
then attach a metal ball.
17.Insert wire D in the pulleys,
then attach a metal ball.
5.Insert wire B in the pulleys,
then attach a metal ball.
Wire D
Wire C
Up/down shaft
18.Insert wire C in the
up/ down shaft, attach
a pulley, and secure the
pulley with an E-ring.
19.Wind wire C around
the pulley by 6 turns in
such a manner that the
wire can be pulled from
over the pulley.
6 turns
16.Insert wire D in the
up/ down shaft, attach
a pulley, and wind wire
D around the pulley by
six turns in such a man-
ner that the wire can be
pulled from over the
pulley.
6 turns