EXTERNAL SECTION
[1] Removing the RADF
Caution:
Make sure power cord of the main unit has
been unplugged from the wall outlet.
a.
Procedure
(1) Remove the rear cover. (See the external section
of the main body.)
(2) Remove two screws to detach the two stoppers.
Screws
Stopper 1
(3) Open the RADF to the upright position.
Screws
Stopper 2
RADF
1-P-1
(4) Remove four connectors (CN612 to CN615)
from the scanner drive board (SCDB) on the
main body.
5
1.
Connector (CN614)
2.
Connector (CN612)
3.
Connector (CN613)
4.
Connector (CN615)
5.
Scanner drive board (SCDB)
(5) Remove four screws to detach the cable conduit.
(6) Draw the cable to the top of the main body.
EDH
1
4
3
2
Cable conduit
Screws (4)