Replacing The C-403 Up/Down Wires - Minolta Di551 Service Manual

C-403 / C-404

[7] Replacing the C-403 Up/Down Wires

Caution: With the power held on, press the LT
tray down switch (SW100) to move the
up/down plate down to the bottom in
advance.
a. Procedure
(1) Open the top cover.
(2) Remove the clutch replacement cover.
(3) Remove five screws to detach the right side
cover.
Right side cover
(4) After opening the jam access door, remove six
screws to detach the front cover.
Caution: When removing the front cover, close
the jam access door after removing
the screws.
Jam access door
Screws
Right side cover
(5) Remove twelve screws to detach the rear cover.
Screws
Screws
(6) Remove the five relay connectors (CN749,
CN780, CN781, CN782, CN783) to disconnect
the wiring harness from the up/down motor
mounting assembly.
(7) Remove the E-ring to detach the up/down gear.
(8) Pull the pin from the shaft.
(9) Remove the E-ring to detach the bearing.
Screws
Screws
1-Q-6
Screw
Screws
Screws
Rear cover