Replacing The Intermediate Conveyance Roller (Sponge Roller) - Minolta Di551 Service Manual

[2] Replacing the Intermediate Convey-
ance Roller (Sponge Roller)
Caution:
Make sure that the power cord of the main
tray is unplugged from the power outlet.
CAUTION: When replacing the sponge rollers,
all of the 2 pairs (4 components)
must be replaced.
a. Procedure
(1) Open the front door.
(2) Remove two screws and a bearing, and detach
the intermediate conveyance rollers.
Intermediate conveyance rollers
(3) Insert the end of the blade screwdriver into the
slot in the sponge roller, and twist the screwdriver
to pry apart.
Conveyance roller (Sponge roller)
(4) Place the two components of a new sponge roller
(5) To reattach the sponge roller shaft, perform the
Bearing
Screw
1-R-7
around the roller shaft so that the tabs of the
components are aligned with the dents on the
shaft. Press the components together firmly until
you hear the "click" sound.
Align
same procedure in reverse order.
CAUTION: When reinstalling the shaft, make
sure that the pin on the far end of the
shaft is placed properly in the slot.
FN-6 / FN-112
Align