Removing And Reinstalling The Adu Reverse Roller - Minolta Di551 Service Manual

[10] Removing and Reinstalling the ADU
Reverse Roller
Warning:
The interlock which is turned OFF when
the front right or left door opens or closes
should never be turned ON forcibly with
the ADU stand drawn out.
Caution:
Be sure the power cord has been
unplugged from the wall outlet.
a. Procedure
(1) Draw out the ADU stand from the main body.
(2) Remove the fixing unit. (See "FIXING UNIT.")
(3) Remove the ADU cover.
(4) Remove the ADU guide cover.
(5) Remove the screw to remove two wiring har-
nesses.
(6) Remove E-ring (1) to remove the paper eject
reverse gear (1) and pin.
(7) Remove E-ring (2) to remove the rear side bear-
ing.
(8) Remove E-ring (3) to remove the front side bear-
ing.
(9) Slide the ADU reverse roller to the upper side
and then to the lower side to slide it out.
1
5
8
9
1. Paper exit reverse gear (1)
2. E-ring (1)
3. Bearing
4. E-ring (2)
5. Pin
6. Wiring harnesses
7. ADU reverse roller
8. Screws
9. E-ring (3)
(10) Reinstall the above parts following the removal
steps in reverse.
1-N-9
ADU UNIT
2
3
4
6
7
3