Removing And Reinstalling The Stapler - Minolta Di551 Service Manual

[3] Removing and Reinstalling the Sta-
pler
Caution:
Make sure that the power cord of the main
body is unplugged from the power outlet.
Caution:
Do not use hands to move stapler units to
horizontal direction.
(Otherwise the belt and the gear teeth skip-
ping may occur.)
Caution:
Be sure to perform the adjustment work
described in the "FNS Stapler Upper/
Lower Positions Adjustment" of the man-
ual, "Adjustment," after you have attached
the stapler.
a. Procedure
(1) Open the front door.
(2) Draw the stacker unit out.
(3) Remove the cartridge from the stapler.
(4) Remove four mounting screws securing the sta-
pler and the screw holding the ground cable.
Detach the stapler/F and the connector (CN181).
1
5
4
1. Stapler/F
2. Screw
3. Connector (CN181)
4. Ground
5. Screw securing the ground cable
(5) Remove two screws holding the sensor cover of
2
3
1-R-17
the stapler/R. Remove the screw securing the
ground cable. Detach the connector (CN182) of
the stapler rotation HP PS (PS713).
1
7
6
5
1. Stapler/R
2. Connector (CN182)
3. Stapler rotation HP PS (PS713)
4. Ground
5. Screw securing the ground terminal
6. Screw
7. Sensor cover
FN-6 / FN-112
2
3
4