Fns Adjusting The Stapling Position (Flat Stapling) - Minolta Di551 Service Manual

[19] FNS Adjusting the stapling position
(Flat stapling)
Caution: Do not use hands to move stapler unit
to horizontal direction.
(Otherwise the belt and the gear teeth
skipping may occur.
1. Tool
• Screwdriver (Phillips)
• Scale
2. Adjustment method
a. Preparation
Step
Perform the following stapling actually and
check whether they are within specifica-
tion. In the case of flat stapling, check
whether the paper edge is parallel to the
virtual line running between the staplers.
One-corner stapling
(at rear)
1
Flat stapling
Parallel
If they are out of spec or not parallel, per-
2
form the following adjustment:
Operation
One-point stapling
(at front)
2-125
b. Adjustment
Step Operation
Open the front door and pull out the stacker
1
unit.
Take off the stapler unit cover.
2
Loosen the adjustment screws for the
clincher /F and Clincher /R and perform
adjustment using marks as a guide.
1
3
1
3
1. Clincher /F
2. Clincher /R
3. Mark
4. Adjustment screw
Execute stapling to confirm that the sta-
4
pling is within the specification range.
ADJUSTMENT
2
2
3
4