Removing And Reinstalling The Clincher - Minolta Di551 Service Manual

Hide thumbs Also See for Di551:

Table of Contents

FN-6 / FN-112

[2] Removing and Reinstalling the

Make sure that the power cord of the main

body is unplugged from the power outlet.

Do not use hands to move stapler units to

horizontal direction.

(Otherwise the belt and the gear teeth skip-

ping may occur.)

Be sure to perform the adjustment work

described in the "FNS Stapler Upper/

Lower Positions Adjustment" of the man-

ual, "Adjustment," after you have attached

the clincher.

(1) Open the front door.

(2) Pull the stacker unit out and remove the stapler

(3) Remove a mounting screw holding the ground

cable. Remove the ground cable and the clamp.

(4) Remove four screws securing the clincher.

Detach the clincher/F and the connector.

(5) Remove four mounting screws holding the

(6) Remove two screws. Detach the ball bearing

bracket, and then remove the clincher/R by rotat-

ing it to the appropriate position. Remove the

CAUTION: Do not lose the bearing spring and

Ball bearing bracket

Bearing spring

(7) Reinstall the above parts following the removal

steps in reverse.

Chapters

Table of Contents