Replacing The Fixing Heater Lamp(L4) - Minolta Di551 Service Manual

FIXING UNIT
[6] Replacing the Fixing Heater
Lamp(L4)
Caution:
Do not touch the fixing heater lamp with
bare hands.
Caution1: Install the heater lamp with the man-
ufacturers mark facing the rear.
Caution2: The heater lamp should not touch
the inner surface of the upper roller.
Caution3: When replacing the heater lamp, be
sure to insert the lamp end in the
lamp terminal securely. Also, check
that the Faston terminals are con-
nected properly.
a. Procedure
(1) Open the fixing cover (upper).
(2) Remove the screw at front to remove the lamp
fixing plate (lower front).
(3) Remove the Faston terminal.
Lamp fixing plate (lower front)
(4) Remove the rear lamp harness from the two har-
ness guide to remove the Faston terminal.
Lamp fixing plate (rear)
(5) Pull out the fixing heater lamp (L4) from the front
Screw
side of the fixing lower roller.
Faston
termonal
(6) Reinstall the above parts following the removal
steps in reverse.
Caution: When installing the lamp, pay atten-
1-O-4
Harness guides
Faston terminal
Fixing heater lamp (L4)
tion to its orientation. The lamp cannot
be installed properly if it is facing the
opposite direction.