Removing And Reinstalling The Second; Paper Feed Unit - Minolta Di551 Service Manual

(4) Remove one screw and remove the registration
roller rotation knob.
Screw
Registration roller rotation knob
(5) Disconnect the relay connector (CN422).
Caution: A relay connector consists of two male
sides and one female side. Be sure to
remove only the male side (shown
below) of the CN422 connector.
(6) Remove the stop ring to detach the registration
MC (MC1).
Caution: When reinstalling, be sure the detent
of the clutch is in the clutch cover
groove.
Registration MC (MC1)
Stop ring
Stopper
Relay connector (CN422)
(7) Reinstall the above parts following the removal
steps in reverse.
[5] Removing and Reinstalling the Sec-
a.
(1) Draw out the ADU stand from the main body.
(2) Detach the ADU cover.
(3) Disconnect the two relay connectors (CN420,
Clutch cover
1-N-3
ond Paper Feed Unit
Warning:
The interlock which is turned OFF when
the front right or left door opens or closes
should never be turned ON forcibly with
the ADU stand drawn out.
Caution:
Be sure the power cord has been
unplugged from the wall outlet.
Procedure
422), and disconnect the relay connector from
the wiring harness.
Caution: Each relay connector consists of two
male sides and one female side. Be
sure to remove only the male side
(shown below) of the connector.
Registration MC (MC1)
Relay connector (CN420)
Relay connector (CN422)
ADU UNIT