Minolta Di551 Service Manual page 279

FN-6 / FN-112
(3) Remove two screws. Detach the wire bracket on
the rear from the up/down stay.
4
3
2
1. Screw
2. Up/down stay
3. Wire bracket
4. Up/down wire
(4) Loosen the two screws on the belt tensioner.
Belt tensioner
1
Screw
1-R-10
(5) Remove the E-ring and the up/down pulley/L.
Then remove the up/down wire.
CAUTION: When you remove the up/down pul-
ley, the pin falls. Be careful not to lose
the pin.
Pins
Up/down pulley/L.
Gear
E-ring
(6) Temporarily attach the wire bracket to the up/
down stay with two screws.
CAUTION: The wire bracket must be installed
with the longer portion of the wire
facing upward.
Longer portion of wire
4
3
Shorter portion of wire
1. Up/down stay
2. Screw
3. Wire bracket
4. Up/down wire
Up/down wire
1
2