Minolta Di551 Service Manual page 181

DRUM UNIT
(7) Remove two screws and detach the separation
claw SD (SD1).
Separation claw SD (SD1)
Screws
(8) Reinstall the above parts following the removal
steps in reverse.
Caution: When installing the separation claw
unit, match the pin and guide hole
shown in the figure.
4
1. Drum unit
2. Pin
3. Separation guide plate assembly
4. Guide hole
[Reference]
When removing the separation claw solenoid
(Normally, it should not be removed except when
replacing the solenoid).
(1) Install the separation claw unit to the drum
(2) Tighten the solenoid screw when the claw
(Bottom surface of the drum unit)
1
(3) Set the drum unit to the main body and
2
3
1-E-6
unit.
closest to the drum touches the drum.
4
3
1. Separation claw SD (SD1)
2. Screws
3. Separation claw
4. Drum unit
check that the tips of the separation claws
are off the drum. (Standard clearance: More
than 0 mm up to 1mm.)
1
2