Removing And Reinstalling The Paper Exit Opening Unit - Minolta Di551 Service Manual

FN-6 / FN-112
[3] Removing and Reinstalling the Paper
Exit Opening Unit
Caution:
Make sure that the power cord of the main
body is unplugged from the power outlet.
a. Procedure
(1) Remove the following parts:
• Top cover/1 or optional PI (if installed)
• Top cover/2
• Side cover
• Rear cover
• Main tray
• Main paper exit opening cover
(2) Remove a mounting screw on the paper exit
open/close link.
Paper exit open/close link
Paper exit opening unit
(3) Remove three screws holding the clamps, one
screw holding the ground. Also remove the con-
nector (CN110) for the paper exit opening SD
(SD704) and the main tray paper exit PS
(PS706).
Screw
(4) Remove the two E-rings and the two shaft hold-
ers (at the front and rear side). Remove the paper
exit opening unit.
Bearing
E-ring
(5) Reinstall the above parts following the removal
steps in reverse.
1-R-8
2
3
4
5
6
4
1. Screw holding the ground cable
2. Paper exit opening SD (SD704)
3. Connector (CN110)
4. Screw holding the clamp
5. Main tray paper exit PS (PS706)
6. Connector
Paper exit opening unit
1
E-ring
Bearing