Minolta Di551 Service Manual page 266

(9) Remove the bearing behind gear C.
(10) Remove the E-ring to remove the up/down gear.
(11) Remove the detent pin for up/down gear from the
up/down pulley shaft.
(12) Remove the E-ring to remove gear D.
(13) Remove the E-ring to remove the remaining
paper detection gear.
(14) Remove four relay connectors (CN780, CN781,
CN782, and CN783) to disconnect the wiring
harness from the up/down motor mounting
assembly.
2
1
7
12
11
10
7
9
1. Remaining paper detection gear
2. Relay connector (CN780)
3. Relay connector (CN781)
4. Relay connector (CN782)
5. Up/down motor mounting assembly
6. Relay connector (CN783)
7. E-ring
8. Bearing
9. Up/down pulley shaft
10. Up/down gear
11. Pin
12. Gear D
3
4
5
6
7
8
1-Q-11
(15) Remove the E-ring to remove the bearing.
(16) Remove the six screws to remove the up/down
motor mounting assembly.
Up/down motor mounting assembly
Bearing
E-ring
(17) Replace the up/down wires following the instruc-
tions in "Removing the Up/Down Wires" and
"Installing Up/Down Wires."
Caution: Two sets of four up/down wires with
different length, one set at the front
and the other at the back, are used.
Wires with the same length can be
used either at the front or back if they
are used in the same location.
1057.3 mm
Wire A
692.1 mm
Wire B
1321.7 mm
Wire C
1303.1 mm
Wire D
C-403 / C-404
Screws
Screws