Isw Trns Messages - Minolta Di551 Service Manual

ISW

ISW TRNS MESSAGES

The ISW Trns program displays dialog messages when errors occur and when processing ends. Definitions
of these messages are listed below, along with the associated display status.
Message
Cannot open a checksum file
Cannot read a checksum file
Cannot open a file
File transmission complete
Cannot open the LPT port
Communications port setup acquisition error
Communications port setup error
Cannot open a send file
Cannot send a Term Test file
Unsuccessful file transmission
Unsuccessful transmission to the LPT port
Starting file transmission. OK?
Send file not selected
Canceled
Default data folder created
Invalid folder name
Default data folder not set.
Set a folder.
Unsuccessful thread creation
Copying the selected file. OK?
Copying all files to the default data folder. OK? File copy start message
No send file available
Unable to copy several files
Display status
Opening of a checksum file failed. Possible causes include
a corrupted file and a file in use.
Loading of a checksum file into memory failed. Possible
causes include a shortage of memory and an OS problem.
Opening of a send file failed. Possible causes include a cor-
rupted file and a file in use.
File transfer completed.
Opening of the LPT port failed.
A call to GetCommSate failed.
A call to GetCommSate failed.
Opening of a send file failed. Possible causes include a cor-
rupted file and a file in use.
Transmission of a communications test block failed.
1. The copier is not ready to receive.
2. The cable is out of position.
3. Transmission of the wrong send file was attempted.
The transmission of a send file failed. Possible causes
include a cable out of position.
Output to the LPT port failed. Possible causes include a
cable out of position.
A message seeking confirmation at the start of file trans-
mission.
No files exist on the send file list.
Transmission of a file in progress was canceled. CANCEL
is normally hidden. Its setting can be altered with the INI
file.
A data folder was created by clicking Create Folder.
An invalid folder name was entered. Start a folder name
with a drive name, such as C:\.
A data folder is not set in ISWTrns.INI. This message is dis-
played when ISW Trns launches for the fist time.
The creation of a thread failed.
File copy start message
No file to copy file is selected or exists in the folder.
1. The destination folder does not exist.
2. When the Overwrite check box is not checked, an
attempt is made to copy to a file having the same file
name.
3. An attempt is made to overwrite a protected file
4. Any other cause (such as a file being used by another
application or OS problem)
5-18