Centring Adjustment - Minolta Di551 Service Manual

3. LCT tray centring adjustment
1
4
C-403
4
3
1. Guide plate/front
2. Guide plate/rear
3. Centre positioning bracket
4. Screws
a.
2
4
4
3
C-404
4
3
2-102
Adjustment method
Step Operation
Raise the up/down plate.
1
Open the top cover.
2
Remove five screws to detach the side
cover (right).
3
Right side cover
Loosen two screws on the upper part of
LCT to slide the guide plates (front/rear)
4
the same amount in the same direction.
Secure the guide plates by tightening two
5
screws firmly.
Loosen three screws to slide the centre
positioning brackets the same amount in
6
the same direction as you did for the guide
plates (front/rear) in the step 4.
Secure the centre positioning brackets by
7
tightening three screws firmly.
Put the LCT back into the original position
8
and make a copy to check the result.
Perform steps 1-8 repeatedly until mis-cen-
tering is included in the automatic adjust-
9
ment range (± 3 mm).
Caution: Disable the mis-centering correction
function by setting the dip switch 12-3
(Enter 1 to set ON) and confirm it.
Confirm it using the test pattern
No.16.
ADJUSTMENT
Screws
Screws