Minolta Di551 Service Manual page 243

FIXING UNIT
[11] Removing and Reinstalling the De-
curler roller
a. Procedure
(1) Remove the fixing unit.
(2) Open the fixing unit (top).
(3) Lift the fixing exit guide plate (upper) and remove
two screws to remove the fixing exit guide plate
(lower).
(4) Remove the screw to detach the jam handling
release knob.
(5) From the front side, remove one E-ring, one gear,
one E-ring, one washer, one screw, and bearing
in this order.
(6) From the rear side, remove one E-ring, one
washer, one screw, and bearing in this order and
then remove the decurler roller from the frame.
1 3
2
11
7
5
1
4
1. Screw
2. E-ring
3. Washer
4. Bearing
5. Fixing exit guide plate (lower)
6. Fixing exit guide plate (upper)
7. Decurler roller
8. Jam handling release knob
9. Gear
(7) Reinstall the above parts following the removal
steps in reverse.
Caution: When reinstalling, check that the gear
is installed correctly.
1-O-8
4
5
1
5
6
1
1
3
2
8
9
2