Minolta Di551 Service Manual page 553

ISW
2. Checking the ROM version of the copier
(before updating)
Before updating ROM data, check the ROM ver-
sion of the existing control program in the 25
mode.
Step Procedure
1 Turn OFF the copier main switch.
2 Turn ON the copier main switch while holding
down the copy count setup buttons 2 and 5, to
enable 25 mode.
3 [25 mode menu window]
Check the ROM version by following the
copier-specific procedure.
Note: For operating instructions, refer to
the Adjustment section of the service
manual supplied for the copier.
3. Preparing the copier to transfer.
Start the copier with 25 mode enabled to put the
copier into ISW transfer wait state.
Step Procedure
1 Turn OFF the copier main switch.
2 Turn ON the copier main switch while holding
down the copy count setup buttons 2 and 5, to
enable 25 mode.
3 [25 mode menu window]
Put the copier into ISW transfer wait state by
following the copier-specific procedure.
Note1: "ISW transfer wait state" is the state
of the copier with the "START" key
being shown in the display area.
Note2: For operating instructions, refer to
the Adjustment section of the ser-
vice manual supplied for the copier.
4. Running ISW Trns.
Run the ISW Trns program.
Step Procedure
1 Boot the PC.
2 Select ISW Trns from the Start menu and run
the ISW Trns program.
5. Selecting transfer file (update data) con-
ditions
Select various conditions for selecting the trans-
fer files (update data) in the ISW Trns main win-
dow. Conditions to select are:
• (Machine) The name of the model on which
ROM data is updated.
• (Country) The destination of the transfer files
(update data)
• (Board) The name of the board on which ROM
data is updated
• (Divide) The type of the transfer files (update
data)
Step
1 [ISW Trns main window]
In the ISW Trns main window, click
[Machine] field in [Select Type] and select the
name of the model on which to update ROM
data from the pulldown menu.
2 In the ISW Trns main window, click
[Country] field in [Select Type] and select the
destination of the transfer files (update data)
from the pulldown menu.
3 In the ISW Trns main window, click
[Board] field in [Select Type] and select the
name of the board on which to update ROM
from the pulldown menu.
5-14
Procedure
in the
in the
in the