Fns Adjusting The Mount Location Of The Alignment Plates / L (Fn-6 Only) - Minolta Di551 Service Manual

b. Adjustment
Step Operation
After loosening two screws to position the
rear side of the alignment plate/U to the
center or marking lines, adjust the location
of its front side so that the mounting loca-
tion is within specification.
Screw
1
Screw
Alignment plate /U
Screw
Alignment plate /U
rear
2-123
[18] FNS Adjusting the mount location of
the alignment plates / L (FN-6 only)
1. Tool
• Screwdriver (Phillips)
• Scale
2. Adjustment method
a. Preparation
Step
Make sure that "Adjusting the mount loca-
1
tion of the alignment plates / U" is finished.
Power on the main body, drive the motor(s)
using the following codes in the 47 mode,
and then power the machine off.
• Code 75-8: Alignment /U (M705) HP
search
2
• Code 75-21: Alignment /L (M716) HP
search
• Code 75-40: Stopper (M718) positioning
shift (larger than A4R)
Open the front door and pull out the stacker
3
unit.
Take off the stapler unit cover.
4
Check whether the actuators for the align-
ment HP/ U (PS705) and the alignment HP/
L (PS724) are aligned with the home posi-
tion.
5
Alignment plate /L
ADJUSTMENT
Operation
Alignment HP/ L (PS724)