Replacing The Fixing Heater Lamps (L2, L3) - Minolta Di551 Service Manual

[5] Replacing the Fixing Heater Lamps
(L2, L3)
Caution:
Do not touch the fixing heater lamp with
bare hands.
Caution1: Install the heater lamp with the man-
ufacturers mark facing the rear.
Caution2: The heater lamp should not touch
the inner surface of the upper roller.
Caution3: When replacing the heater lamp, be
sure to insert the lamp end in the
lamp terminal securely. Also, check
that the Faston terminals are con-
nected correctly.
a. Procedure
(1) Remove the fixing unit.
(2) Remove the fixing unit front cover.
(3) Remove the screw at the front to remove the
lamp fixing plate (front).
(4) Remove the front lamp harness from the harness
guide to remove the two Faston terminals.
Caution: When removing the Faston terminals,
be sure to hold the connector. Con-
nector cannot be removed by pulling
on the harness.
4
1. Faston terminals (2)
2. Screw
3. Harness guide
4. Lamp fixing plate (front)
(5) Open the fixing unit (top).
(6) Remove the screw at the far side to remove the
lamp fixing plate (rear).
(7) Remove the two Faston terminals of the far side
(8) Pull out the fixing heater lamps (L2, L3) from the
1
2
3
(9) Reinstall the above parts following the removal
1-O-3
lamp.
Caution: When removing the Faston terminals,
be sure to hold the connector. Con-
nector cannot be removed by pulling
on the harness.
Faston terminals (2)
Screw
Lamp fixing plate (rear)
front side of the fixing upper roller.
Fixing heater lamps (L2, L3)
steps in reverse.
Caution: When installing the lamps, pay atten-
tion to their orientation. The size of the
lamp terminal mounting hole in the
front lamp fixing plate is different from
that in the rear lamp fixing plate. The
lamp cannot be installed properly if it
is facing the opposite direction.
FIXING UNIT