Minolta Di551 Service Manual page 269

C-403 / C-404
(18) After installing the up/down wires, check whether
they are engaged with the pulleys properly and
whether they do not ride over the pulleys. Next,
move the up/down plate manually to check
whether it moves up and down smoothly.
Caution: If the up/down plate does not move
smoothly, remove the up/down wires
and install them again.
(19) Install the up/down motor mounting assembly,
relay connectors, remaining paper detection
gear, gear D, and up/down gear following the
removal steps in reverse.
(20) Rotate the remaining paper detection gear until
the round hole in this gear is aligned with the
oblong hole in the up/down motor mounting
assembly.
4
1. Remaining paper detection gear
2. Up/down motor mounting assembly
3. Round hole
4. Oblong hole
Caution: Align them when the up/down plate is
at the bottom.
(21) Install gear C.
(22) Attach the other gears, gear cover, and external
covers following the removal steps in reverse.
Caution: After replacing the up/down wires,
make horizontal and centering adjust-
ment of the up/down plate. (Refer to
"ADJUSTMENT SECTION.")
1
2
3
1-Q-14