Fns Adjusting The Mount Location Of The Paper Exit Arm - Minolta Di551 Service Manual

Step Operation
Place the solenoid to its original position,
and tighten the screw securing the sole-
noid bracket at the position where the
paper exit guide makes contact with the
cushioning rubber of the paper exit guide
stay.
Caution: Make sure that the difference in
height between the paper exit
guide and the paper exit guide
stay is 1mm and greater.
2
1
3
5
1mm
1. Stopping rubber
2. Solenoid bracket
3. Screws
4. Paper exit guide stay
5. Paper exit guide
Reassemble in the opposite sequence to
4
the removal.
[16] FNS Adjusting the mount location of
1.
2.
a.
Step
3
4
5
2-121
the paper exit arm
Tool
• Screwdriver (Phillips)
Adjustment method
Preparation
Operation
Open the front door and pull out the stacker
1
unit.
When aligning the actuator edge of the belt
detection gear with the notch of panel /rear,
check whether the top surface of paper exit
belt arm is positioned in the middle of the
two marks.
Notch of panel /rear
Belt detection gear
2
Top surface of paper exit belt arm
Perform the adjustment if it is out of spec.
3
ADJUSTMENT
Actuator edge
Marks