Vertical Conveyance Section; Removing And Reinstalling The Vertical Conveyance Section; Removing And Reinstalling The Vertical Conveyance Mc (Mc11, Mc12) - Minolta Di551 Service Manual

VERTICAL CONVEYANCE SECTION

[1] Removing and Reinstalling the Verti-
cal Conveyance Section
Caution:
Be sure the power cord has been
unplugged from the wall outlet.
a. Procedure
(1) Remove all right side covers. (See "EXTERNAL
SECTION.")
(2) Disconnect the connector (CN880).
(3) Remove eleven screws to remove the vertical
conveyance section.
4
1. Vertical conveyance door
2. Vertical conveyance section
3. Connector (CN880)
4. Screws (11)
(4) Reinstall the above parts following the removal
steps in reverse.
Caution: When installing the vertical convey-
ance section, be sure to secure the
screws with the vertical conveyance
door closed.
[2] Removing and Reinstalling the Verti-
cal Conveyance MC (MC11, MC12)
a. Procedure
(1) Remove the vertical conveyance section.
(2) Remove the gear lock to remove the two gears
and two spacer axes.
(3) Disconnect the two connectors (CN881, CN882)
to remove the wiring harness from the harness
guide.
(4) Remove each MC.
1
2
3
(5) Reinstall the above parts following the removal
steps in reverse.
Caution: When installing, be sure the detent of
1-M-1
VERTICAL CONVEYANCE SECTION
Caution:
Be sure the power cord has been
unplugged from the wall outlet.
1
5
6
5
1. Connector (CN881)
2. Vertical conveyance MC/1(MC11)
3. Connector (CN882)
4. Vertical conveyance MC/2(MC12)
5. Spacer axis
6. Gear
Vertical conveyance MC
Detent
the clutch is at the position shown
above.
2
3
4