[14] FNS Adjusting the Shift Position
1.
Tool
• Screwdriver (Phillips)
2.
Adjustment method
a.
Preparation
Step
Remove the following parts.
• Top cover or option PI (if installed)
1
• Top cover /2
Power on the main body and drive the roller
shift (M702) using the 47 mode (code 75-2/
2
75-3).
At the both HP (home position) and shift
position, check whether the edge of the
actuator for the slide gear fits into the
notched hole of the slide stay.
2
1
3
5
1.
Slide gear
2.
Notch
3.
Actuator
4.
Shift unit
5.
Slide stay
If the edge of the actuator for the slide gear
does not fit into the notched hole of the
4
slide stay, perform the following adjust-
ment:
Operation
3
4
2-119
b.
Adjustment
Step
Operation
Loosen the screw fastening the bracket for
the roller shift HP PS (PS718), and shift the
bracket to adjust the amount of discrep-
ancy using the mark as a guide.
1
1
1.
Shift HP PS (PS718)
2.
Bracket
3.
Mark
4.
Screw
When the position is confirmed, fasten the
2
screw securing the bracket.
Reassemble in the opposite sequence to
3
removal.
ADJUSTMENT
2
3
4