Fns Adjusting The Paper Exit Solenoid - Minolta Di551 Service Manual

[15] FNS Adjusting the paper exit solenoid

1. Tool
• Screwdriver (Phillips)
• Scale
2. Adjustment method
a. Preparation
Step
Remove the following parts.
• Top cover /1 or option PI (if installed)
1
• Top cover /2
• Rear cover
Power on the main body, and turn on the
paper exit solenoid (SD704) using the 47
2
mode (code 75-31).
With the paper exit solenoid (SD704) ON,
check whether the gap between the
plunger of solenoid and the stopper of the
bracket is within the spec value.
Spec value: A=6.5 ± 0.5 mm
3
If the gap is out of spec, perform the follow-
4
ing adjustment.
Operation
Paper exit nip SD
(SD704)
2-120
b. Adjustment
Step Operation
Remove two screws securing the solenoid
bracket and remove the solenoid together
with the bracket.
1
Loosen the 2 screws holding the solenoid,
move the solenoid to adjust its position,
and retighten the screws.
Spec value: A = 6.5 ± 0.5 mm
Paper exit SD
(PS704)
2
Screws
ADJUSTMENT
Screws
Solenoid bracket