Fns Adjusting The By-Pass Gate - Minolta Di551 Service Manual

[13] FNS adjusting the by-pass gate

1. Tool
• Screwdriver (Phillips)
• Scale
2. Adjustment method
a. Preparation
Step
Open the front door.
1
Draw out the stacker unit.
2
Remove the 2 screws securing the rail
stopper, and pull out the stacker unit even
further.
Caution: To prevent the finisher from top-
pling over, place a board or the
like to support the pulled-out
unit.
3
Stacker unit
Board to prevent the Finisher
from toppling over
Open the by-pass conveyance guide plate.
4
Operation
Rail stopper
securing screw
2-117
Step Operation
When the by-pass gate (SD705) is OFF,
check the gap between the by-pass gate
and the by-pass conveyance plate is within
the standard value.
Specifications: A=3.2 ± 0.5 mm
5
1
1. By-pass gate
2. By-pass conveyance plate
If the gap is not within the standard value,
6
perform the following adjustment.
ADJUSTMENT
1
2