Web-Hmi Overview; Dashboard Overview - ABB Eagle Programming Manual

4. Web-HMI Overview

Once logged in, the Web-HMI presents a Dashboard view and other Menu options along
with the status of device Flags. Flags are status information of important events that need
user attention.

4.1. Dashboard overview

The Dashboard of EAGLE Single phase recloser looks as in Figure 5. The Dashboard displays
a Single line diagram (SLD) where the status of the circuit breaker (CB) is displayed. The
RED color of the breaker indicates CB is closed and Green indicates that the CB is open.
Close and Open buttons are provided below the SLD for easy controlling of the EAGLE
circuit breaker.
The Dashboard also displays the fundamental component of the measured primary
current in Amperes, MAC address of the device.
Dashboard provides easy Enable/Disable button for Auto reclose (AR) function, Non-
Reclose Mode (NRM), Cold Load Pickup (CLP) and Operating Mode functionality. Enabling
of each of these functions is shown by "Green" indication and the Disable is shown by
"Grey' color. Operating mode functionality works only in station mode.
When "Operating Mode" is enabled user will not be able to enable/disable Auto Reclose
function, Non-Reclose Mode, Cold Load Pickup operation using Web-HMI. User will be
able to do these operation through DNP3 only.
If the recloser goes through a complete AR sequence and reaches the Lockout state, it can
be reset using the RESET button on the Dashboard.
The following status information is shown on the Dashboard
For the sake of clarity, of this document will describe the features as
available to users with "Admin" credentials.
DeviceAdmin password is used for authentication of DNP3 and HTTPS
messages for communication between LRC and Eagle. This password is
different from Admin password.
Please refer to Section 7 to a full explanation regarding station mode.
Above operation is only possible if LRC and Eagle devices have same
DeviceAdmin password.
11