Nortel DMS-100 Series Replacement Procedures page 539

CM MS
. .
RCO2
0 Quit
2 Post_
3 ListSet
4
5 TRNSL_
6 Tst_
7 Bsy_
8 RTS_
9 OffL
10 LoadPM_
11 Disp_
12 Next
13
14 QueryPM
15 DCH
16
17
18
Use the following information to determine the next step in this procedure.
If faults are
not indicated
indicated
31 Send any faulty cards for repair according to local procedure.
32 Record the date the card was replaced, the serial number of the card, and the
symptoms that prompted replacement of the card.
If you entered this procedure
from
alarm clearing procedures
other
33 Return to Alarm and Performance Monitoring Procedures or other procedure
that directed you to this procedure. At the point where a faulty card list was
produced, identify the next faulty card on the list and go to the appropriate
card replacement procedure for that card in this manual.
34 Obtain further assistance in replacing this card by contacting the personnel
responsible for higher level of support.
35 You have successfully completed this procedure. Remove the sign from the
active unit and return to the maintenance procedure that directed you to this
card replacement procedure and continue as directed.
DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up
XPM card replacement procedures (continued)
in an RSC-S (PCM-30) Model B RCO2
IOD Net PM
. . .
SysB ManB
PM 0 0
RCO2 0 0
RCO2 0 InSv Links_OOS:
Unit0: Act InSv
Unit1: Inact InSv
QUERYPM FLT
Unit0 No troubles exist
Unit1 No troubles exist
CCS Lns Trks
. . .
OffL CBsy
0 0
0 0
CSide 0, PSide
Do
step 31
step 34
Do
step 33
step 35
1-507
NTBX02
(end)
Ext Appl
. .
ISTb InSv
0 25
0 1
0