Nortel DMS-100 Series Replacement Procedures page 409

Hide thumbs Also See for DMS-100 Series:

Table of Contents

By observing the MAP display, ensure that the card to be removed is on the

inactive unit.

At the RSCE frame

Place a sign on the active unit bearing the words Active unit—Do not touch.

This sign should not be attached by magnets or tape.

At the MAP terminal

Busy the inactive PM unit by typing

>bsy unit rcc2_unit_no

and pressing the Enter key.

rcc2_unit_no

is the number of the inactive RCC2 unit (0 or 1)

DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up

XPM card replacement procedures (continued)

Static electricity damage

Before removing any cards, put on a wrist strap and connect

it to the wrist strap grounding point on the left side of the

frame supervisory panel (FSP) of the RCC2. This protects

the equipment against damage caused by static electricity.

in an RSC RCC2