Nortel DMS-100 Series Replacement Procedures page 411

9 Open the locking levers on the replacement card.
a Align the card with the slots in the shelf.
b Gently slide the card into the shelf.
10 Seat and lock the card.
a Using your fingers or thumbs, push on the upper and lower edges of the
faceplate to ensure the card is fully seated in the shelf.
b Close the locking levers.
At the MAP terminal
11 After replacing the faulty card, load the inactive RCC2 unit by typing
>LOADPM UNIT rcc2_unit_no CC
and pressing the Enter key.
where
DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up
XPM card replacement procedures (continued)
in an RSC RCC2
1-379
NTBX01
(continued)