Nortel DMS-100 Series Replacement Procedures page 390

1-358 XPM card replacement procedures (continued)
NTAX78
in an SMA
(continued)
6
7
8
297-8021-547 Standard 14.02 May 2001
SMA SysB ManB
PM 3
SMA 0
SMA 0 ISTb Links_OOS:
Unit0: Act InSv
Unit1: Inact ISTb
Observe the MAP display and determine if the faulty card is in the active or
the inactive unit.
If faulty card is on
active unit
inactive unit
Switch the activity of the units by typing
>SWACT
and pressing the Enter key.
A confirmation prompt for the SWACT command is displayed at the MAP
terminal.
If SWACT
can continue at this time
cannot continue at this time
Confirm the system prompt by typing
>YES
and pressing the Enter key.
The system runs a pre-SWACT audit to determine the ability of the inactive
unit to accept activity reliably.
Note: A maintenance flag appears when maintenance tasks are in
progress. Wait until the flag disappears before proceeding with the next
maintenance action.
If the message is
SWACT passed
SWACT failed
XPM,SWACTback
SWACT refused by SWACT
Controller
Offl CBsy ISTb
0 1 0
0 0 0
CSide 0, PSide 0
Do
step 7
step 10
Do
step 8
step 23
Do
step 10
step 9
Reason:
step 9
InSv
2 13
1 7