Nortel DMS-100 Series Replacement Procedures page 951

SMA
PM
SMA
SMA 0 ISTb
Unit0:
Unit1:
6 Observe the MAP display and determine if the faulty card is in the active or
the inactive unit.
If the faulty card is in the
active unit
inactive unit
7 Switch the activity of the units by typing
>SWACT
and pressing the Enter key.
A confirmation prompt for the SWACT command is displayed at the MAP
terminal.
If SWACT
can continue at this time
cannot continue at this time
8 Confirm the system prompt by typing
>YES
and pressing the Enter key.
The system runs a pre-SWACT audit to determine the ability of the inactive
unit to accept activity reliably.
Note: A maintenance flag appears when maintenance tasks are in
progress. Wait until the flag disappears before proceeding with the next
maintenance action.
If the message is
SWACT passed
SWACT
XPM SWACTback
SWACT refused by SWACT
Controller
DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up
XPM card replacement procedures (continued)
SysB ManB Offl
3 0 1
0 0 0
Links_OOS: CSide 0, PSide 0
Act InSv
Inact ISTb
failed Reason:
in an SMA
CBsy ISTb InSv
0 2 13
0 1 7
Do
step 7
step 10
Do
step 8
step 29
Do
step 10
step 9
step 9
1-919
NTMX71
(continued)