Nortel DMS-100 Series Replacement Procedures page 772

1-740 XPM card replacement procedures (continued)
NTEX17
in an RLCM
(continued)
14
297-8021-547 Standard 14.02 May 2001
DANGER
Risk of personal injury
Make sure you handle the line card carefully. The line feed
resistor can be very hot. To avoid injury, use the
insertion/withdrawal tool to remove the card as shown in the
figure that follows.
Remove the line card to be replaced by using the following substeps:
a Slide a card shroud over the card to be removed and an adjacent card. If
there is not an adjacent card on either side, do not use the card shroud.
b Grasp the edge of the card with a line card extractor at a point midway
between the top and bottom edges. Hold the extractor in your right hand.
c Squeeze the handles of the extractor together to grasp the card tightly.
Insertion/withdrawal
tool