Nortel DMS-100 Series Replacement Procedures page 893

Hide thumbs Also See for DMS-100 Series:

Table of Contents

Place the card that you removed in an electrostatic discharge (ESD)

protective container.

Make sure that the replacement card and the card that you remove have the

same PEC and PEC sufﬁx.

Close the locking levers on the replacement card. Align the card with the pin

slots in the drawer. Carefully slide the card into the drawer.

Support the drawer with your left hand. Use your right hand to push on the

upper and lower edges of the card. Make sure that the card sits completely

in the drawer.

Note: Do not use a rocking motion to insert the card.

DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up

XPM card replacement procedures (continued)