Delta AH500 Hardware Operation Manual page 579

A H 5 0 0 H a r d w a r e a n d O p e r a t i o n M a n u a l
Error
Description
Code
The data which is received through
16#6208 the TCP socket exceeds the
device range.
The local communication port set
16#620A in the UDP socket function is
illegal.
The remote communication port
16#620B set in the UDP socket function is
illegal.
The device from which the data is
16#620C sent in the UDP socket function is
illegal.
The transmitted data length set in
16#620D
the UDP socket function is illegal.
The data which is sent through the
16#620E UDP socket exceeds the device
range.
The device which receives the data
16#620F in the UDP socket function is
illegal.
The received data length set in the
16#6210
UDP socket function is illegal.
The data which is received through
16#6211 the UDP socket exceeds the
device range.
There is no response from the
16#6212 remote device after the timeout
period. (Socket)
The data received exceeds the
16#6213
limit. (Socket)
The remote device refuses the
16#6214
connection. (Socket)
16#6215 The socket is not opened.
16#6217 The socket is opened.
The data is being sent through the
16#6218
socket.
1 2 - 3 0
Solution
1. Check the program and the related special data
registers.
2. Set the Ethernet parameter for the CPU module in
HWCONFIG again.
1. Check the program and the related special data
registers.
2. Set the Ethernet parameter for the CPU module in
HWCONFIG again.
1. Check the program and the related special data
registers.
2. Set the Ethernet parameter for the CPU module in
HWCONFIG again.
1. Check the program and the related special data
registers.
2. Set the Ethernet parameter for the CPU module in
HWCONFIG again.
1. Check the program and the related special data
registers.
2. Set the Ethernet parameter for the CPU module in
HWCONFIG again.
1. Check the program and the related special data
registers.
2. Set the Ethernet parameter for the CPU module in
HWCONFIG again.
1. Check the program and the related special data
registers.
2. Set the Ethernet parameter for the CPU module in
HWCONFIG again.
1. Check the program and the related special data
registers.
2. Set the Ethernet parameter for the CPU module in
HWCONFIG again.
1. Check the program and the related special data
registers.
2. Set the Ethernet parameter for the CPU module in
HWCONFIG again.
Make sure that the remote device is connected.
1. Check the program and the related special data
registers.
2. Set the Ethernet parameter for the CPU module in
HWCONFIG again.
Make sure that the remote device operates normally.
Check whether operational sequence in the program is
correct.
Check whether operational sequence in the program is
correct.
Check whether operational sequence in the program is
correct.