Delta AH500 Hardware Operation Manual page 456


Synchronic R/W
Generally speaking, a master station sends a writing command and a reading command to a slave station
separately. If the Synchronic R/W checkbox is selected, the master station can complete reading and
writing simultaneously by means of a specific Modbus function code (the hexadecimal code 17), and the
efficiency of data exchange is increased. However, the users have to make sure that the devices involved
in data exchange support the Modbus function code before they select the Synchronic R/W checkbox. If
the devices do not support the Modbus function code, the Modbus code can not be identified, and the
reading/writing of data will fail after they receive the commands from the master station.

Run PLC Link after downloading
If the Run PLC Link after downloading checkbox is selected, the PLC Link constructed will be enabled
after the PLC Link constructed is downloaded to the PLC connected to the computer.

Interval Time (ms)
The users can specify how often the master station sends a command.
After the users click
system will lead the users to the previous step.
11.1.2.4 Creating a Data Exchange Table (Step 3)
A. Introduction of a Data Exchange Table
The table below is a data exchange table. When a PLC Link is executed, the master station sends
reading/writing commands to the slave stations according to the data exchange table created.
, the system will lead the users to the next step. If the users click
C h a p t e r 11 C o n v e n i e n t F u n c t i o n s
, the
11 - 7