Delta AH500 Hardware Operation Manual page 31

A H 5 0 0 H a r d w a r e a n d O p e r a t i o n M a n u a l

AHCPU560-EN2 provides one Eurpean terminal block control interface (COM).

Users can set the DB9 serial control interface to RS-232 or RS-485, according to the application
environment. The data transfer rate can be increased from 9600 bps to 1 Mbps.

AH500 redundant series CPU module (AHCPU560-EN2): After users set in HWCONIFG in ISPSoft,
they can exchange the data with a device through the RS-485 serial control interface, and do not need
to write any program.
11. High-speed Ethernet communication interface

AHCPU500/501/510/511/520/521/530/531-EN and AHCPU521-DNP is equipped with a 10/100 M
Ethernet communication interface, and supports emails, webs, and socket services.

AH500 basic series CPU module (AHCPU500/510/520/530): After users set the PLC Link in
NWCONIFG in ISPSoft, they can exchange the data with a device network through the Ethernet
communication interface, and do not need to write any program.

AH500 advanced series CPU module (AHCPU501/511/521/531 and AHCPU521-DNP): After users
set in HWCONIFG or EIP Builder (for CPU module FW: V2.00.0 or later) in ISPSoft, they can
exchange the data with a device through the Ethernet communication interface, and do not need to
write any program.

AH500 redundant series CPU module (AHCPU560-EN2): After users set in HWCONIFG or EIP
Builder in ISPSoft, they can exchange the data with a device through the Ethernet communication
interface, and do not need to write any program.

The status or the error message related to the system is sent to users' email boxes immediately. Users
do not need to be on the spot to understand the problem.
12. Memory card

The memory card has the following functions.
System backup: The user program, the CPU parameters, the module table, the setting value in the
device
System recovery: The user program, the CPU parameters, the module table, and the setting value in
Parameter storage: The value in the device
Log storage: The system error log and the system status log
13. Hot swap

The AH500 series I/O modules support the on-line uninterruptible hot swap. When the system runs,
users can replace the module which breaks down without disconnecting the module. After the module
is replaced, the new module runs normally. Users do not need to set the module manually or switch
the state.
1 - 1 6
the device