Port -Based Q- In -Q; Cli Configuration - Tripp Lite NGI-M08POE8-L2 Owner's Manual

6.3.7.2 Port-Based Q-in-Q

6.3.7.2.1 CLI Configuration

Node Command
enable show vlan-stacking
portbased-qinq
enable configure terminal
configure interface IFNAME
interface vlan-stacking port-based
priority <0~7>
interface vlan-stacking port-based role
(tunnel|access|normal)
interface vlan-stacking port-based
spvid <1~4096>
interface vlan-stacking tunnel-tpid
index <1-6>
configure interface range
gigabitethernet1/0/PORTLIS
TS
if-range vlan-stacking port-based
priority <0~7>
if-range vlan-stacking port-based role
(tunnel|access|normal)
if-range vlan-stacking port-based
spvid <1~4096>
if-range vlan-stacking tunnel-tpid
index <1-6>
Description
This command displays the port-based q-in-Q
configurations.
This command changes the node to configure
node.
This command enters the interface configure
node.
This command sets the priority in port based Q-
in-Q.
This command sets VLAN stacking port role.
This command sets the service provider's VID of
the specified port.
This command sets TPID for a Q-in-Q tunnel
port.
This command enters the if-range configure
node.
This command sets the priority in port based Q-
in-Q.
This command sets VLAN stacking port role.
This command sets the service provider's VID of
the specified port.
This command sets TPID for a Q-in-Q tunnel
port.
137