Multi Shot - Xerox WorkCentre C226 User Manual

Copier Operation

Multi shot

2-64
• Place ~70 x 100mm (2-1/2" x 4"), ~65 x 70mm (2-1/2" x 2-1/2") and ~57 x 100mm
(2-1/8" x 3-5/8") originals as shown below.
Centring Scale
Placing a
~70 x 100mm
(2 ½" x 4") or
~57 x 100mm
(2 " x 3 ")
1 8 / 5 8 /
original
To cancel the PHOTO REPEAT function, select the PHOTO REPEAT function again
and touch the [CANCEL] key (step 2).
The multi shot function is used to copy up to four originals, collectively in a specified
order, per sheet of copy paper in any one of four layout patterns.
[Example] Copying seven originals using the 4 in 1 MULTI SHOT selection in a layout
pattern starting from the upper left to lower right.
One-sided copies
from one-sided
originals
One-sided copies
from two-sided
originals
• When using the multi shot function, place the originals, select the desired paper
size, and select the copying mode before selecting the multi shot function on the
special modes screen.
• When using the multi shot function, the appropriate copy ratio will be automatically
set based on the original size, paper size, and the number of originals to be copied
onto one sheet. The minimum possible reduction ratio is 25%. Depending on the
original size, paper size, and the number of originals to be copied onto one sheet,
the copy ratio required to fit the original images onto one sheet may be smaller
than 25%. In this case, a ratio of 25% will be used, and parts of the original images
may be cut off.
Centring Scale
Placing a
~65 x 70mm
(2 ½" x 2 ½")
original
Copies
Xerox WorkCentre C226 User Guide