Xerox WorkCentre C226 User Manual page 429

Problem
Printing does not take
place after reception.
A received image
prints out blank.
The received image
is faint.
The received image
is distorted.
White or black lines
appear in the trans-
mitted image.
A dial tone is not
heard through the
speaker.
A ringing sound is
not made.
Xerox WorkCentre C226 User Guide
Check
Does a message appear in
the display instructing you to
add toner or paper? (Printing
is not possible.)
Was the wrong side of the
original scanned in the trans-
mitting machine?
Is the original faint?
Were line conditions poor
due to thunder or another
reason?
Is the document glass dirty?
Is the volume set to "low"?
Has the ringer volume been
turned off?
Solution
Restore printing capabil-
ity as instructed by the
display message. Print-
ing will begin
Check with the operator
of the transmitting
machine.
Ask the other party to re-
send the document
using a suitable expo-
sure setting.
Ask the other party to
send the document
again.
Clean the document
glass .
Set the speaker volume
to "medium" or "high".
Set the ringer volume to
"low", "medium", or
"high".
Problems and Solutions
Page
"When an Alarm
Sounds and a Warning
Message Is Displayed"
on page 5-98
_
_
_
Pages 2-81 and 2-82
"Speaker volume set-
ting" in the "Fax Unit"
section of the Work-
Centre C226 System
Administration Guide
"Speaker volume set-
ting" in the "Fax Unit"
section of the Work-
Centre C226 System
Administration Guide
5-101