Misfeed In The Transport Area, Fusing Area, And Exit Area - Xerox WorkCentre C226 User Manual

Misfeed in the transport area, fusing area, and exit area

NOTE:
NOTE:
NOTE:
Xerox WorkCentre C226 User Guide
Transport area
1. Open the upper side cover and check for a misfeed.
If paper is loaded in the Bypass Tray, temporarily remove the paper and close the
Bypass Tray before opening the side cover.
The misfeed may have occurred inside the machine. Check carefully and remove it.
2. Gently close the upper side cover.
Even after clearing a misfeed, paper may remain inside the machine on the transfer
belt where it is not visible. In this case, after visible misfeeds are removed, the paper
on the transfer belt will be automatically moved to a position where it is visible and a
misfeed will be indicated once again on the display. Clear the misfeed as explained in
"Misfeed in the transfer unit" (step 3 on page 1-51). For this reason, it may be
necessary to perform the "Misfeed in the transfer unit" procedure twice.
After closing, confirm that the misfeed message has
been cleared and the normal display appears. If the
Duplex Bypass/Inverter Unit is not installed, close the
side cover in the same way.
Push the lever upward and gently open the cover.
Be careful not to tear the misfed paper during
removal.
Misfeed Removal
1-49