Interface Settings; Default Paper Type For Bypass Tray; Job Queuing; Port Switching Method - Xerox WorkCentre C226 User Manual

Printer Operation
3-56

Default paper type for Bypass Tray

This program is used to set the default paper type for paper loaded in the Bypass Tray
in printer mode. "NONE" (a default paper type is not selected), "PLAIN", "HEAVY
PAPER", or ''TRANSPARENCY" can be selected. If "HEAVY PAPER" is selected,
select "HEAVY PAPER 1" or "HEAVY PAPER 2". If "TRANSPARENCY" is selected,
select "SPEED MODE" or "QUALITY MODE".
The factory default setting is "NONE".

Job queuing

This program is used to allow new print jobs to be received while a print job is in
progress. Normally the program is enabled so that new print jobs can be received.

Interface settings

These programs are used to control data transmitted to the parallel port or network
port of this printer.

Port switching method

The machine can use the three ports shown below for printing. This program is used to
select when switching between ports will take place. "SWITCH AT END OF JOB" or
"SWITCH AFTER I/O TIMEOUT" can be selected. When "SWITCH AT END OF JOB"
is selected, the port will be automatically selected after each print job is completed.
When "SWITCH AFTER I/O TIMEOUT" is selected, the port will be automatically
selected if the time set in the I/O Timeout program elapses.
• Parallel port
• USB port
• Network port

Enable parallel port

This program is used to enable or disable printing from the parallel port.
Default setting: Enable

Enable USB port

This program is used to enable or disable printing from the USB port.
Default setting: Enable

Enable network port

This program is used to enable or disable printing from the network port.
Default setting: Enable
Xerox WorkCentre C226 User Guide