Selecting The File Format - Xerox WorkCentre C226 User Manual

Network Scanner Operation
NOTE:
NOTES:

Selecting the File Format

4-38
2. Touch the desired resolution key.
Auto
Exposure
Lowest
Lower
Resolution
Standard
Programmed
File Format
Higher
Auto
Highest
Original
Five selections are available for the resolution. Touch the desired resolution key
under black and white or colour, depending on the original to be scanned.
The selected key is highlighted.
To use colour 600 x 600 dpi, one 256-MB and one 128-MB memory module (or two
256-MB memory modules) must be added to the printer controller, and one 128-MB or
256-MB memory module must be added for image memory. For more information, see
page 4-1.
3. Touch the [OK] key.
Colour
OK
pi 100x100dpi
pi 150x150dpi
pi 200x200dpi
pi 300x300dpi
• The initial factory resolution setting is LOWER. If desired, you can change the
initial setting to a different setting using the key operator program, "Initial
resolution setting" (page 4-66.
• The resolution setting cannot be changed once scanning has begun.
When you send an image to one or more recipients using Scan to E-mail or Scan to
FTP, the [FILE FORMAT] key enables you to temporarily override the individual file for-
mat settings (FILE TYPE / COMPRESSION MODE) stored for each recipient and
send the image to all of the recipients using a single file format setting.
"PROGRAMMED" is initially selected, which means that the file format settings stored
for each recipient are used.
B/W Colour
OK
150x150dpi 100x100dpi
200x200dpi 150x150dpi
300x300dpi 200x200dpi
400x400dpi 300x300dpi
600x600dpi 600x600dpi
You will return to the initial screen.
Xerox WorkCentre C226 User Guide