Peripheral Devices; Saddle Stitch Finisher; Part Names And Functions - Xerox WorkCentre C226 User Manual

Saddle Stitch Finisher

Part names and functions

NOTES:
Xerox WorkCentre C226 User Guide

Peripheral Devices

This section explains procedures for using the peripheral devices such as the Saddle
Stitch Finisher.
The Saddle Stitch Finisher can automatically place two staples for centreline binding
of prints or copies and fold them along the centreline. An optional hole punching unit is
available for installation into the finisher.
• Do not press on the Saddle Stitch Finisher (particularly the offset tray).
• Use caution when near the offset tray during printing as the tray moves up and
down.
• To install the Saddle Stitch Finisher, a Duplex Bypass/Inverter Unit and either a
stand/1-Tray Unit, a 3-Tray Unit, or a Duplex Module/2-Tray Unit must also be
installed.
Saddle Stitch Finisher
Stapler compiler
Open for misfeed
Paper to be stapled is
removal.
stacked temporarily.
When printing on post
cards or envelopes,
remove the output from
here.
Open the front cover
and pull out this
section to replace the
Offset tray
staple cartridge or to
Output which is stapled
remove jammed
or offset will be
staples.
delivered to this tray.
Open to replace the
staple cartridge, to
Saddle stitch tray
remove the misfed
Saddle stitched output
paper, or to remove
is delivered here.
jammed staples.
Top cover
Stapler section
Front cover
1-59