Sending An Image; Basic Transmission Method - Xerox WorkCentre C226 User Manual

Basic Transmission Method

NOTE:
NOTES:
Xerox WorkCentre C226 User Guide

Sending an Image

1. Make sure the machine is in scanner mode.
/
to the base screen of scan/fax mode.
2. Load the original.
You cannot load documents in both the DADF and on the document glass and send
them in a single transmission.
3. Check the original size.
Lower
Resolution
Programmed
File Format
Auto A4
Original
• To scan a two-sided original, refer to page 4-32.
• To rotate the document image 90° before transmission, see page 4-34.
When the [IMAGE SEND] key light is on, the machine is
in scanner mode. If the light is not on, press the [IMAGE
SEND] key.
When the optional Fax Unit is installed, you will return to
the base screen of fax mode or scan/fax mode,
depending on which mode was last selected. If the base
screen of fax mode appears, touch the
key (see *1 on page 4-19 to switch
Scanner Fax
For detailed information on loading an original, refer to
page 2-4.
The original size is automatically detected.
If you loaded a non-standard size document or wish to
change the scanning size, touch the [ORIGINAL] key
and set the document size. (Refer to page 4-34.)
Basic Transmission Method
4-23