Xerox WorkCentre C226 User Manual page 160

Copier Operation
2-56
(A) Use these keys to select the colour to be adjusted ([C] = cyan, [M] = magenta, [Y]
= yellow, [Bk] = black).
If only the area around the letter inside a key is highlighted, the settings have been
changed from the factory default settings.
(B) Use these keys to change the densities of all eight levels at once.
When either key is touched, the indicator lines of all eight levels will move up or
down one step.
(C) Use these keys to adjust the densities of each of the eight density levels.
When one of the keys is touched, the corresponding indicator line will move up or
down one step. Touch the
level, or the key to decrease the density.
(D) Use this key to return the densities of all eight levels to the initial settings.
The initial colour balance settings are the values set with key operator program
"Initial colour balance setting". For this reason, the initial settings may not
necessarily be 0 (the middle indicator position) for all levels. The initial setting of
each level is shown by a grey indicator.
When the colour balance setting is adjusted, the colour adjustments menu icon (
will appear at the upper left of the screen to indicate that the function is turned on.
3. Touch the [OK] key (inside [OK] key) on the COLOUR BALANCE setting screen.
Return to the COLOUR ADJUSTMENTS menu screen.
4. Touch the [OK] key on the COLOUR ADJUSTMENTS menu screen.
Return to the SPECIAL MODES screen.
5. Touch the [OK] key on the SPECIAL MODES screen.
Return to the main screen of copy mode.
About the steps that follow
If a DADF is being used, see pages 2-13 through 2-19. If the document glass is being
used, see pages 2-21 through 2-24.
In either case, press the [COLOUR COPY START] key to begin copying.
To cancel the COLOUR BALANCE function, select the COLOUR BALANCE function
again and touch the [CANCEL] key (step 2).
key to increase the density of the corresponding
Xerox WorkCentre C226 User Guide
)