Table of Contents
Advertisement
Setup Paper Trays
Note
It is possible to configure your Xerox Nuvera with two or more Sheet Feed Modules (SFM), effectively
doubling the feed capacity of the system. Notify your Xerox sales representative if you wish to configure
your system in this way. See
Sheet Feed Modules (SFM)
for more details.
Note
If your Xerox Nuvera is configured with two or more Sheet Feed Modules, pay special attention to how
the trays are displayed in the user interface. For example, tray 2 in the first SFM will appear as "Feeder
1: Tray 2". Tray 1 in the second SFM will appear as "Feeder 2: Tray 1."
Avoiding Multi-Sheet Feeds When Using Special
Stocks
There may be times when the paper loaded in the paper trays does not feed correctly. The Xerox Nuvera
will notify you of the problem with a message on the user interface screen.
Stock types include:
• paper backed transparencies
• envelopes
• some label types
If these stock types are not properly loaded and programmed in the system, they will be detected as
multi-sheet feeds.
The solution to avoiding multi-sheet feeds and/or jams is to make sure the actual contents of a given
tray match the
settings you program using the user
interface.
For more information, see
Clearing Paper
Jams.
Loading Paper
Load paper as indicated by the labels on each paper tray. If you are using the 2-Tray Feed Module, load
paper as indicated for trays 3 and 4 of the 4-Tray Feed Module.
Note
If printing on coated stock but only one side is coated, load the coated side up.
Systems with the Multifunction Finisher DO NOT support coated stock.
Note
Stocks greater than 300 gsm are not recommended for use with the Xerox Nuvera. For details on using
the correct stocks, see
Supported
Paper.
Note
Loading papers of varying types and weights may warrant adjustment of the Sheet Enhancement
Module. For details, see
Managing Paper
Curl.
Xerox
®
Nuvera
®
11-5
User Guide and Training Aid (UGTA)
Advertisement
Table of Contents
