Automatic Two-Sided Copying From The Dadf - Xerox WorkCentre C226 User Manual

Automatic two-sided copying from the DADF

NOTE:
Xerox WorkCentre C226 User Guide
3. Touch [OFFSET].
4. Touch [OK].
Ready To Copy.
Output
Sort
Left Tray
Group
Selecting the output tray
When the [LEFT TRAY] key in the above illustration is highlighted, copies are output to
the tray on the left side of the machine (the left tray). When the [CENTRE TRAY] key is
highlighted, copies are output to the centre tray. Touch the key of the tray you wish to
use for copy output.
Turning on the offset function
The offset function operates when a checkmark appears in the [OFFSET] checkbox,
which is displayed by touching the [CENTRE TRAY] key. (If a checkmark doesn't
appear, touch the checkbox.)
Offset width: Approximately 30 mm (1-3/10")
(A3W (12" x 18") paper cannot be offset.)
When a Duplex Module/2-Tray Unit and a Duplex Bypass/Inverter Unit are installed,
the following automatic two-sided copy functions are possible. The copy paper is
turned over automatically, allowing easy two-sided copying.
Certain restrictions exist depending on the amount of memory installed and the copy
settings. (See "Copy mode output restrictions" on page 2-16 and "Guidelines for the
number of scannable originals during sort copying" on page 2-17.)
0
Interrupt
OK
Offset
Centre
Tray
Normal Copying
2-19